Its raining today and I noticed the driver's wiper wasn't doing a great job, that'll fail inspection so I grabbed new ones, figured I might as well replace both.
Thats the end of the wiper, its a weird slide in sleeve thing. The wipers have to be in "wipe" position to lift the arms too, weird...
Much fiddling with adaptors
Until finally...
Okay, off to the inspection station:
Rats!
This actually isn't so bad, a black R is not safety related and you can drive the car, in this case its because some emissions sensors are reading "not ready". This is probably because the dealer I bought the car from had to have a DPF regen performed at the dealer. DPF = Diesel Particulate Filter, and a regen is when it burns off the built up particulate. If the car had been mostly city driven on short trips the filter could fill up early and not get to burn off which is why it needed a dealer regen. I drive mostly on the highway which is ideal and shouldn't have an issue, also VW has been forced to issue a long warranty on the DPF and finally the aftermarket has "DPF Delete" options for "off road use only".
So anyway the plan is to put a couple hundred miles on the car and try again in a couple weeks.
Finally I tried to set the clock and clear the "Oil/Inspect" notice in the dash. Both require pressing the odo reset button which I tried and didn't seem to work. So being an optimist I pulled the dash cluster.
Its super hard to see but the problem is right where my finger is, the contacts for the button are on the green board under that white lump and theres a white bump of powdery corrosion. I squirted a little De-Oxit in there and worked a piece of paper towel in to remove the corrosion.
Reinstalled, tested and the clock is correctly set. You might also notice in this picture I've forgotten to reinstall the two screws that hold the cluster in place. I didn't remember until I started writing this blog entry, I had to pull the trim again and reinstall.
Even with having to redo the trim the whole process took less than an hour. Yes I could have made then dealer fix it but its a half hour drive to the dealer, time to get it fixed and half an hour home, in the end its just as fixed and I know more about the car and I took a moment to De-Oxit the other side while I was there.
Last thing, I picked up some nylon washers for the license plate screws. I'd bought some stainless steel screws but they're just a little too long. I could have cut them but I was a little worried about corrosion on the cut edge, the stainless screws you get at the hardware store aren't the finest stainless in then world...