Monday, May 1, 2017

Loader advancement

Finally got some more time with the loader, first off that stupid top link had to go.

There was a little tension in it... That Harbor Freight 7" angle grinder was a good investment, its a little low on power when I really play the gorilla and lean on it but it does a good job.


Outgoing at the top, incoming below. 2.5"x.18", way overkill but I figured go big or go home. That turned out to bite me later on.

Lookin good right?


Heres the problem, thats my new 10" hydraulic cylinder replacing the 16" that was there, notice how the bucket is tipped slightly down but the cylinder is sucked all the way in. The bucket can't curl up any... Turns out when I had measured to replace the cylinder I'd measured to the TOP of the new brace. I should have bought an 8" cylinder and 2" tube steel. In the first step I shortened my top mount which helped a little but not enough, the second step involved modifying the bucket.


I cut the cylinder mounts off the bucket and moved them 2.5" down. While I was at it I took off the 1.25" bushings and installed proper 1" so the pin won't beat itself to death.


The bucket curls correctly now. Theres still more work to do, I need to go back and pretty up the new mounts, probably box them in some for added strength too. Then I want to cut the bucket down considerably. Its waaaay to heavy for this application. Its 47" wide where the plans I bought call for 42". I think considering how heavily its built I'll cut it all the way down to 40". I'll lower the top by 3" and pull in the leading edge by 4". Is that easier than making a bucket from scratch? I don't know but the ribs on this one make it super strong which is why its super heavy. Once its done I'll never hurt it...